Certain acoustic problems often result from improper design or from construction limitations. If large echoes are to be avoided, focusing of the sound wave must be avoided. Smooth, curved reflecting surfaces such as domes and curved walls act as focusing elements, creating large echoes and leading to bad texture. Improper blend results if sound from one part of the ensemble is focused to one section of the audience. In addition, parallel walls in an auditorium reflect sound back and forth, creating a rapid, repetitive pulsing of sound known as flutter echo and even leading to destructive interference of the sound wave. Resonances at certain frequencies should also be avoided by use of oblique walls.

Acoustic shadows, regions in which some frequency regions of sound are attenuated, can be caused by diffraction effects as the sound wave passes around large pillars and corners or underneath a low balcony. Large reflectors called clouds, suspended over the performers, can be of such a size as to reflect certain frequency regions while allowing others to pass, thus affecting the mixture of the sound.

External noise can be a serious problem for halls in urban areas or near airports or highways. One technique often used for avoiding external noise is to construct the auditorium as a smaller room within a larger room. Noise from air blowers or other mechanical vibrations can be reduced using techniques involving impedance and by isolating air handlers.

Good acoustic design must take account of all these possible problems while emphasizing the desired acoustic features. One of the problems in a large auditorium involves simply delivering an adequate amount of sound to the rear of the hall. The intensity of a spherical sound wave decreases in intensity at a rate of six decibels for each factor of two increase in distance from the source, as shown above. If the auditorium is flat, a hemispherical wave will result. Absorption of the diffracted wave by the floor or audience near the bottom of the hemisphere will result in even greater absorption, so that the resulting intensity level will fall off at twice the theoretical rate, at about 12 decibels for each factor of two in distance. Because of this absorption, the floors of an auditorium are generally sloped upward toward the rear.